Woohoo!! The first big print on the MK4 is done! It’s gorgeous! The file was pre sliced with the printer and the filament is PLA gravity Grey hex. Yes the cross section really is hexagonal 😄
Woohoo!! The first big print on the MK4 is done! It’s gorgeous! The file was pre sliced with the printer and the filament is PLA gravity Grey hex. Yes the cross section really is hexagonal 😄 https://t.co/jKSirviUM0
@elianarose66 Can you try the same piece on the Bambu lab? 🙏
@elianarose66 Nice. I have 4 plates of prints ready to go that should keep it running up to tomorrow's call. Nothing huge, but I am doing a couple 12+ hour jobs back to back.
@elianarose66 I'm seeing a lot of ringing and a pretty bad layer shift at the top? Has this not been fully calibrated yet?